The startmonkey200 is the
world's smallest hand held "jump start" system for car
batteries. It can restart a standard 12 volt battery between
15 and 20 times and it’s packed with high-tech safety
features to give you total piece of mind. It is so easy to
use. Included in the pack is a mains power charger that can
be used in over 150 Counties.
Startmonkey200 is easy to use. For the average car with a flat
battery, firstly ensure the engine battery is 12 volts (if 5
or 24 volts - DO NOT USE with Startmonkey200). Check the
battery capacity level
in the Startmonkey200 and then simply
attach the jump leads (red-to-red, black-to-black) to your
car battery and the Startmonkey200 will automatically start
delivering 120 amps of continuous power. Leave the Startmonkey200 for 5-8 seconds, and then turn the ignition on
your car and your car will start.
If the car fails to start, leave the Startmonkey200 connected
for between 10 and 15 minutes and then turn the ignition
again.
Once your car starts, disconnect the Startmonkey200 and store
in case provided.
On the front of the
Startmonkey200 is a 4-segment LED array.
When the Startmonkey200 is fully charged, all four segments of
the array will be GREEN. When it is 3/4 charged, three
segments will be GREEN and when it is 1/2 charged, two
segments will be GREEN. When the Startmonkey200 only has a 1/4
charge left, the LED turns RED. It is recommended that the
Startmonkey200 be recharged when it gets to 50%.
The Startmonkey200 has an input socket so you can recharge it
via the supplied in-car charger; this will take about 4
hours to charge a Startmonkey200 with a 50% level of charge
remaining. From empty, the Startmonkey200 will be recharged via
the in-car charger in 8 hours. The Startmonkey200 can also be
recharged via the solargorilla, the AC mains charge from the
powergorilla and the forthcoming silverback-gorilla. The
input socket can even take voltages between 15 - 24 volts to
recharge the Startmonkey200.
The DC output socket on the
Startmonkey200 means you can also
charge your portable gadgets! Simply connect the included
in-car charger socket to the DC output port, pop the
included motormonkey into that and using an approved USB
cable (not supplied) and tips, you can recharge your phone,
iPod, PDA, handheld games consoles and more! You can even
use the in-car charger socket with your 12-volt in-car
chargers to operate your laptop, GPS system, etc.
The Startmonkey200 has very low static wastage - meaning you
can leave it unused for up to three years and it will still
hold up to 75% of its power! It can also be recharged 500
times - so if your battery is still going flat after all
that time - it may be time to get a new car!
Startmonkey200 dimensions:
174 x 46.5 x 49 mms
Safety Precautions:
Ensure the Startmonkey200 is placed on a stable, secure
location i.e. outside edge wing of car, so that is cannot
fall into the engine bay.
Do not leave Startmonkey200 in engine bay once the car has
started.
Do not connect Startmonkey200 to a 5-volt or 24-volt battery,
as this will damage the Startmonkey200.
Safety Features:
Two output level protection features
Cannot 100% drain itself - self-protects
Balance charging and discharging
Short-circuit protection
Wrong polarity protection
Over-charge protection
Integrated software to control charging procedure
Low battery warning display
ONLY to be used with 12-volt vehicle engine batteries e.g.
cars, bikes, boats, lawnmowers, etc.
Approvals:
CE, FCC, RoHS, E-Mark, Green Dot and WEEE
Caution:
Do not open the device or attempt to disassemble or modify
the device, as this will invalidate the warranty/guarantee.
This may also result in the risk of fire, personal injury or
damage to personal property. Please refer to user guide for
full operating instructions.
Bonus:
Includes International
Adapter for A/C Mains Power. This is the universal AC
Startmonkey200 charger. It works in over 150 countries
around the world, so now you have no excuse for not being
able to charge your Startmonkey200 to the max!